Vertical WAVE IP 2500 Installation Manual page 27

'ZRCPUKQP QRVKQPU
The ISC1 is the minimum requirement for a Wave IP 2500 system. There are several ways to
expand the Wave IP 2500 base unit to support a wide variety of trunk and station configurations:
• Expansion cards and modules. The Wave IP 2500 supports two kinds of expansion
boards, cards and modules:
• Modules are partial-width boards that can be installed in module slots or universal
slots in the base unit or in Expansion Units (EXUs), described on page 3-4.
The following modules are available:
•
•
•
•
• Cards are full-width boards that support higher port densities than modules. Cards
can be installed in the universal slots in the base unit or in EXUs.
Analog trunk module. Supports 8 analog FXO loop start or ground start
trunk ports.
Analog universal module. Supports 8 analog FXS station ports and 8 analog
FXO loop start or ground start trunk ports.
Digital station module. Supports 12 digital station ports.
T1 module with drop-and-insert (DNI) V.35 serial interface. Supports a
single T1 PRI digital trunk. It features an integrated CSU/DSU, and allows
shared data and voice services over a single T1 circuit.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide