Vertical WAVE IP 2500 Installation Manual page 40

Wave IP 2500 Installation Guide
6.
7.
/QFWNG CPF ECTF UVCVWU .'&U
Each module and card has a pair of LEDs that indicate the item's status:
4GCF[
ITGGP
ON
OFF
ON
OFF
Note:
lights for the T1 and serial ports that are located to the left of the module status LEDs.
%QPPGEVKPI OQFWNGU CPF ECTFU
This section provides instructions for connecting trunks, stations, and other devices to modules
and cards.
Important:
tasks have been completed, depending on your configuration:
•

Install blank faceplates on all unused slots.
Reconnect the Wave IP 2500 and all EXUs to power.
'TTQT 5VCVWU
TGF
OFF Normal state—module or card is fully operations.
ON Initial state when Wave IP 2500 is powered on; module or
card has not yet initialized.
ON Software is initializing.
If module or card remains in this state after the Wave IP
2500 is fully operational, module or card initialization has
failed.
OFF No power to the module or card, or a fatal error has
occurred.
The T1 module with drop-and-insert V.35 serial interface has an additional set of status
Before performing the steps in the following sections, ensure that the following
The punchdown block or multiport adapter has been properly wired by a
telecommunications professional.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute