Vertical WAVE IP 2500 Installation Manual page 57

6.
7.
8.
9.
10. To verify that the HotFixes were applied successfully, click Software Versions in the
#FFKPI VJG 9CXG +2  VQ [QWT .#0
Before performing the following tasks according to the steps in this section, be sure that you
have successfully connected the Wave IP 2500 to your LAN according to the steps on page 3-9.
•
•
Once the upgrade process starts, you will be alerted on the progress of the upgrade via the
SNMP Alarms applet. Minimize the SNMP Alarms window so that you can see the next
message.
When you see the following message, click Done to close the Software Upgrade applet
and return to the Global Administrator Management Console.
"Upgrade Status Upgrade request successful. InstantOffice System upgrade will
start momentarily."
Restore the SNMP Alarms window and monitor it until the "Rebooting InstantOffice"
entry appears. The Wave IP 2500 restarts one or more times, depending on the number of
restarts required by the HotFixes that you installed. This process may take 10 minutes or
more.
HotFix installation is complete when the blink pattern of the red LED at the far right
Note:
of the ISC1 changes from a fast double blink to a steady single blink.
Once the Wave IP 2500 restarts for the final time, log on again to the Wave IP 2500 again
using your Wave user name and password.
General Administration section of the Global Administrator Management Console. The
top entry shows the latest release. HotFix entries are listed in the order that they were
applied, using the following format:
[Day] [Date] [Year] [Time]= [HotFix information]
Changing the IP network settings of the following components on the Wave IP 2500:
• Integrated Services Card (ISC1)
• Vertical Application Module (VAM)
• Media Resource Module (MRM), if one is installed
Configuring the Wave IP 2500 for one-click license activation. In order to activate
your Wave licenses using one-click activation, the Wave IP 2500 must be able to connect
to the Internet and communicate with the Vertical Activation Server. Make sure that the
settings in the IP Network Settings dialog box are correctly set so that gateway and DNS
servers have external access. (For more about license activation, see page 5-6.)
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide