Vertical WAVE IP 2500 Installation Manual page 53

%QPPGEVKPI VQ VJG 9CXG +2  XKC C OQFGO
You can use a local or remote modem connection to connect to the Wave IP 2500 from the
administrator PC for system configuration.
The following terms are used throughout this section:
• Wave modem: The answering modem, included with the Wave IP 2500 base unit and
located on the ISC1. The Wave modem can be reached through any trunk port or any
analog station port on the Wave IP 2500. The IP address of the Wave modem is always
192.168.210.1.
• Client modem: The calling modem, installed on the administrator PC. The following
client modems have been certified for use with the Wave IP 2500. Other modems may
also work, but only these models have been tested so far by Vertical. The IP address of
the client modem is in the range of 192.168.210.2 to 192.168.210.10.
• USRobotics USB Mini Faxmodem Model 5635
• USRobotics Internal 56K Faxmodem PCI Model 5699B
• USRobotics Serial V.90 56K Sportseter Model 0701
• Zoom V.90/V.92 Faxmodem Series 0269
• Remote connection: A modem connection made through a trunk port on the Wave IP
2500. By default, the Wave modem is configured to answer on the third analog trunk port
of the ISC1. You can use the Hunt Groups and Trunk Groups applets in the Global
Manager Administrative Console to configure the Wave modem to answer on any other
digital or analog trunk. (Modem throughput will often be much better on a digital trunk.)
• Local connection: A modem connection made through an analog station port on the
Wave IP 2500. Although less useful than a remote connection, a local modem connection
can be made through any analog station port on the Wave IP 2500. The default Wave
modem extension is 570.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide