Vertical WAVE IP 2500 Installation Manual page 36

Wave IP 2500 Installation Guide
2QYGT HCKNQXGT UWRRQTV
The Wave IP 2500 provides for failover telephone service in the event of a power failure.
If the power fails, the analog phone connected to station port 1 on the ISC1 automatically
connects to the analog trunk plugged into trunk port 1, enabling the analog phone to make calls
even if the Wave IP 2500 is not functioning.
Hint:
as the lobby or front desk.
+PUVCNNKPI GZRCPUKQP EQORQPGPVU
This section describes how to install the following components to expand the Wave IP 2500
base unit:
•
•
•
+PUVCNNKPI ':7U QP C 9CXG +2 
You can install up to 4 EXUs on a Wave IP 2500.
6Q KPUVCNN CP ':7
1.
2.
3.
4.

When setting up stations, connect station 1 to a phone located in an accessible area, such
Expansion Unit (EXU). See the next section.
Media Resource Module (MRM). See page 3-14.
Expansion cards and modules. See page 3-15.
Unplug the Wave IP 2500's power cord, but do not disconnect the grounding wire.
Remove the connector hatch retention screws on the top of the Wave IP 2500 base unit,
and then remove the connector hatch.
Remove the backplane terminator from the base unit using both hands to pull it straight
up and out.
Caution:
Make a note of the direction that the backplane terminator is facing when you
remove so that you can replace it the same way. A reversed backplane terminator can cause
malfunctions and damage equipment.
Open the side and rear latches on the EXU.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute