Vertical WAVE IP 2500 Installation Manual page 41

• Analog and T1 trunks have been installed by your service provider.
• Incoming analog DID trunks have been tested to ensure no voltage is present, as well as
to verify that they are DID trunks.
See the following sections for information about connecting each of the supported modules and
cards:
• Analog trunk module. See page 3-17.
• Analog universal module. See page 3-18.
• Digital station module. See page 3-18.
• T1 module with drop-and-insert V.35 serial interface. See page 3-19.
• Analog station card. See page 3-19.
• Digital station card. See page 3-20.
Caution:
Ensure that only analog phones are connected to analog station ports and only
digital phones to digital station ports. This will prevent damage to the analog circuitry.
%QPPGEVKPI VJG CPCNQI VTWPM OQFWNG
The analog trunk module provides 8 analog FXO loop start or ground start trunk ports. It is a
partial-width module that can be installed in any module slot or in any universal slot via a
module carrier.
See Appendix A, "Trunk and Station Ports and Pinouts" for RJ-21X interface port descriptions
and pinout pairs for the analog trunk module.
6Q EQPPGEV VJG CPCNQI VTWPM OQFWNG
1. Locate the RJ-21X port on the module.
2. Connect the analog trunk or station cable to the RJ-21X port.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide