04/SHOCK ABSORBER, SWINGARM
Assembling the piston rod
6.17
–
Clamp the piston rod with the heim joint into a vise.
–
Mount rubber buffer
300410-10
–
Position special tool
Mounting sleeve (T313) (
–
Grease the seal ring and slide seal ring retainer
Lubricant (T625) (
–
Remove the special tool.
300411-10
–
Mount supporting plate
300412-10
–
Mount compression shim stack
300413-10
–
Grind the piston on both sides on a surface plate with sandpaper grit 1200.
–
Mount the piston.
Guideline
View
View
–
Clean the piston.
300415-10
–
Mount the piston.
300414-10
and locking cap
.
on the piston rod.
p. 148)
p. 141)
with the round side first.
with the smaller disks facing down.
Piston from above
Piston from below
on the piston rod.
31