Table of Contents
Advertisement
30/ASSEMBLING THE ENGINE
Installing timing chain rails
20.13
Installing rotor
20.14
Adjusting crankshaft position sensor distance
20.15
–
Position the timing chain securing guide
Info
The cable of the crankshaft position sensor must be laid in the cable chan-
nel of the timing chain securing guide.
–
Thread in the timing chain tensioning rail
ing into the timing chain securing guide.
300046-11
–
Thread in the timing chain guide rail
the timing chain securing guide.
–
Mount and tighten screws
Guideline
Screw, timing chain guide
rail
Screw, timing chain ten-
sioning rail
300045-11
Info
Ensure that there is no thread locking material at the collar of the screw;
otherwise, the timing chain tension rail could lock and break.
–
Check both timing chain rails for freedom of motion.
–
Ensure that the spring washer
–
Degrease the cone of the crankshaft and the rotor.
–
Mount the rotor.
Info
Make sure that the crankshaft is not blocked.
–
Use the special tool to hold the rotor tight.
Holding spanner (75029091000) (
300042-10
–
Mount the tab washer and the nut
Guideline
Rotor nut
300043-10
–
Adjust the distance between the crankshaft position sensor
element of the rotor using the special tool
Guideline
Crankshaft position sensor/rotor - dis-
tance
Feeler gauge (59029041100) (
–
Fully tighten screws
Guideline
300048-10
Screw, ignition pulse gen-
erator
.
from above. Insert the support bush-
from above. Insert the support bushing into
.
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
is seated properly.
p. 219)
. Tighten nut.
M18x1.5
.
0.70 mm (0.0276 in)
p. 214)
.
M6
10 Nm
(7.4 lbf ft)
143
Loctite
®
243™
Loctite
®
243™
100 Nm
(73.8 lbf ft)
and the conductive
Loctite
®
243™
Advertisement
Table of Contents
