Burkert 8692 Operating Instructions Manual page 44

Process valve Types 2300 and 2301
Figure 21: Rotating the actuator module
→
Using a suitable open-end wrench, counter the wrench flat on the pipe.
→
Process valves Types 2300 and 2301:
Spezialschlüssel genau in die Schlüsselkontur an der Unterseite des Antriebs einpassen.
(The special key is available from the Bürkert sales office. Order number 665702).
→
Process valves belonging to series 27xx:
Place suitable open-end wrench on the hexagon of the actuator.
WARNING!
Risk.of.injury.from.discharge.of.medium.and.pressure!
If the direction of rotation is wrong, the body interface may become detached.
▶ The actuator module must.only.be.turned.in.the.specified.direction.(see "Figure 22: Specified direction of
rotation and tool for turning the actuator module")!
→
Process valves Types 2300 and 2301:
Rotate clockwise (as seen from below) to bring the actuator module into the required position.
→
Process valves belonging to series 27xx:
Rotate counter-clockwise (as seen from below) to bring the actuator module into the required position.
Process valves belonging to series 27xx
Figure 22: Specified direction of rotation and tool for turning the actuator module
44
Key contour
Nipple
Open-end wrench
english
Actuator module
Process valves belonging to series 27xx
Special key
Process valve Types 2300 and 2301
Type 8692, 8693
Installation
Hexagon
Nipple