Start-Up.profibus.dp; Start-Up.profibus.dp; Safety.instructions; Start-Up.sequence - Burkert 8692 Operating Instructions Manual

Type 8692, 8693
PROFIBUS DP
29 START-UP PROFIBUS DP
29.1 Safety instructions
WARNING!
Risk.of.injury.from.improper.operation!
Improper operation may result in injuries as well as damage to the device and the area around it
▶ Before start-up, ensure that the operating personnel are familiar with and completely understand the contents
of the operating instructions.
▶ Observe the safety instructions and intended use.
▶ Only adequately trained personnel may start up the equipment/the device.
Before start-up, carry out pneumatic, fluid and electrical installation of Type 8692/8693 and of the valve.
For a description see chapters "12" and "28".
29.2 Start-up sequence
For start-up of Type 8692/8693 PROFIBUS DP the following basic settings are required:
Device.type Sequence Type.of.basic.setting
8692 and
1
8693
8692 and
1
8693
For.8693.only
2
(Process
control)
3
4
8692 and
8693
5
Table 102: Start-up sequence for PROFIBUS DP
Enter the operating mode of the valve actuator.
Generally not required for the initial start-up!
The operating mode of the actuator has been
preset in the factory.
Adjust device to the local conditions
Activate process controller.
Settings on Type 8692/8693:
Input device address.
Activate or deactivate safety position.
Configuration via the control
(PROFIBUS DP Master):
Configuration of the process values
1. PDI: Process data input
2. PDO: Process data output.
Setting.via Description.
in.chapter
ACTUATOR "22.1"
X.TUNE "22.3"
ADD.FUNCTION "23"
BUS.COMM "29.3"
PROFIBUS DP
Master by means
"29.4"
of GSD file and
special software
english
199