13.2.3 Installing electronics module and housing jacket
NOTE!
Be.careful.not.to.damage.the.pins.at.the.PCB!
• Position the electronics module straight and do not tilt when pressing down.
→
Attach electronics module carefully and press down evenly until the holders snap into place.
→
Check that the seal is correctly positioned on the housing jacket.
Figure 31:
Position seal housing jacket
NOTE!
Breakage.of.the.pneumatic.connection.pieces.due.to.rotational.impact!
▶ When inserting the housing jacket, do.not.hold.the.actuator but the electrical connection housing above.
→
Place the housing jacket over the electronics module and screw it in until the stop position; while doing so,
hold the electrical connection housing (screwing tool available via the Bürkert Sales Center. Order number
674077).
NOTE!
Malfunction.due.to.ingress.of.dirt.and.moisture!
To comply with the degree of protection IP65 / IP67, make sure that the housing jacket and the electrical con-
nection housing are screwed together tightly.
→
Switch on operating voltage at the device and the proximity switch connector.
→
Restart operation of Type 8692/8693.
56
english
Type 8692, 8693
Installation
Seal
Housing jacket