Pid.parameter.-.Parameterizing.the.process.controller; Procedure For Inputting The Parameters - Burkert 8692 Operating Instructions Manual

Type 8692, 8693
Start-Up
24.3 PID.PARAMETER – Parameterizing the process
controller
The following control parameters of the process controller are manually set in this menu.
DBND 1.0 % Insensitivity range (dead band) of the process controller
KP 1.00 Amplification factor of the (P-contribution of the PID controller)
TN 999.0 Reset time (I-contribution of the PID controller)
TV 0.0
Hold-back time (D-contribution of the PID controller)
X0 0.0 % Operating point
FILTER 0 Filtering of the process actual value input
The automatic parameterization of the PID controller integrated in the process controller
(menu options KP, TN. TV) can be implemented with the aid of the P.TUNE function
(see chapter "24.5 P.TUNE – Self-optimization of the process controller").
Basic information for setting the process controller can be found in chapters "39 Properties of PID Con-
trollers" and "40 Adjustment rules for PID Controllers".
24.3.1 Procedure for inputting the parameters
The settings in the PID.PARAMETER menu are always made in the same way.
Procedure:
Key Action
/ Select PID.PARAMETER
ENTER
Press
/ Select menu option
INPUT
Press
/
Increase value
Reduce value
or
<–
Select decimal place
Increase value
OK Press
EXIT Press
EXIT Press
EXIT Press
* The description of the submenus of PID.PARAMETER can be found in the following chapters.
Table 43: PID.PARAMETER; parameterizing process controller
If the submenu is left by pressing the left selection key
Description
The menu for parameterizing the process controller is displayed.
The input screen is opened.
Set value when
DBND X.X % / X0
*
Set value when
KP X.XX / TN
*
Return to PID.PARAMETER.
Return to P.CONTROL.
Return to the main menu (MAIN).
Switching from setting level
ESC , the value remains unchanged.
0 % / FILTER
5 :
X.0 sec / TV 1.0 sec :
process level.
English
97