Burkert 8692 Operating Instructions Manual page 162

TRAVEL.ACCU –.Path.accumulator
The path accumulator records and adds up the path which the actuator piston covers. A movement of the
actuator piston is detected when the position changes by at least 1 %.
The interval for outputting messages is specified by inputting a limit for the total number of piston movements.
• To do this, a history entry is made in the HISTORY submenu. For description see "25.2.21.7. History entries in
the HISTORY submenu".
• The status signal, which is assigned to the message, is indicated at short intervals on the display.
See also D.MSG and CONFIG.MSG in chapter "25.2.21.5", page 154.
Display.TRAVEL.ACCU
TRAVEL.ACCU
STROKE
LIMIT 1000000 cm
NEXT.M 999954 cm
HISTORY
29-6-1
EXIT
Table 83: TRAVEL.ACCU; path accumulator
Operating structure:
TRAVEL.ACCU
* Input required for analog position sensor only
Figure 102: Operating structure TRAVEL.ACCU
162
Description.of.the.functions
The STROKE submenu specifies the total stroke of the actuator piston. The
total stroke is automatically determined during the basic setting of the device
20.0.mm
(running X.TUNE).
In the case of an analog position sensor, the total stroke must be input by
pressing the
The interval for outputting the message can be changed in the LIMIT
INPUT
submenu. A piston movement which covers 10 km has been preset at the
factory.
After NEXT.M the remaining piston movement distance is displayed until the
next message appears.
The history entries of the last 3 messages can be viewed and deleted in the
HISTORY submenu.
STROKE
ENTER
LIMIT
NEXT M.
EXIT HISTORY
english
INPUT key.
INPUT
Input total
stroke*
INPUT
Input
Limit
Display the remaining distance until the next message
ENTER
History entry
is displayed
Type 8692, 8693
Auxiliary functions
OK
ESC
OK
ESC
Delete.history.entry
CLEAR
EXIT