Burkert 8692 Operating Instructions Manual page 161

Type 8692, 8693
Auxiliary functions
SERVICE.TIME –.Operating-hours.counter
The operating-hours counter records the time during which the device was switched on.
If the duty cycle reaches the specified time limit, a message is generated.
• To do this, a history entry is made in the HISTORY submenu. For description see "25.2.21.7. History entries in
the HISTORY submenu".
• The status signal, which is assigned to the message, is indicated at short intervals on the display.
See also D.MSG and CONFIG.MSG in chapter "25.2.21.5", page 154.
Display.SERVICE.TIME
SERVICE.TIME
LIMIT 90d. 00h
NEXT.M
89d. 23h
HISTORY
29-5-1
EXIT INPUT
Table 81: SERVICE.TIME; operating-hours counter
Operating structure:
SERVICE.TIME
ENTER
EXIT
Figure 101: Operating structure SERVICE.TIME
Specifying.interval.for.the.output.of.messages
Key Action
/ Select SERVICE.TIME
ENTER
Press
/ Select LIMIT
INPUT Press
/
Increase value
<
Change the
(time unit: d/h/m)
OK
Press
EXIT Press
Table 82: SERVICE.TIME; specifying interval.
Description.of.the.functions
The interval for messages preset at the factory for 90 days can be
changed in the LIMIT submenu.
After NEXT.M the remaining time is displayed until the next message
appears.
The history entries of the last 3 messages can be viewed and deleted in
the HISTORY submenu.
LIMIT INPUT
Input interval
Display the remaining time until the next message
NEXT M.
HISTORY ENTER
History entry
is displayed
Description
(To do this, the SERVICE.TIME function must be incorporated into
the DIAGNOSE main menu. See chapter "25.2.21.4. Activation of
diagnosis functions").
The menu is displayed.
The preset value is displayed.
Set interval for outputting the message.
Return to the SERVICE.TIME menu.
Return to the DIAGNOSE main menu.
OK
ESC
Delete.history.entry
CLEAR
EXIT
english
161