Burkert 8692 Operating Instructions Manual page 147

Type 8692, 8693
Auxiliary functions
25.2.20.1. SIGNAL.sim – Simulation of the set-point value
The settings to simulate the set-point value are made in the SIGNAL.sim menu.
Activation.of.the.simulation:
The following parameters can be set for the selected waveform.
Menu.option Parameter.setting
Offset (Zero offset as %)
Amplitude (Amplitude as %)
Perisode (Cycle duration in s)
Table 69: SIGNAL.sim; parameter settings for set-point value simulation
Deactivation.of.the.simulation: In the SIGNAL.form submenu
Activating.and.parameterizing.the.set-point.value.simulation:
Key Action
MENU Press for approx. 3 s
/ Select SIMULATION
ENTER Press
In the SIGNAL.form submenu by selecting one of the following waveforms
Sine wave
Sine
Square wave
Square
Triangle wave
Triangle
Single cycle of an alternating signal sequence.
Mixed
Then the selection is set to Extern (set-point value simulation
inactive).
Schematic.representation.with.sine.wave
70 %
50 %
70 %
50 %
70 %
50 %
Extern
Selection = set-point value simulation inactive
(corresponds to the factory setting in the as-delivered state)
Description
Switching from process level
(To do this, the auxiliary function must be incorporated into the main
menu).
The submenu for setting the simulation is displayed.
Offset as %
Amplitude as %
Period in s
setting level.
english
t
t
t
147