Rotating.the.actuator.module - Burkert 8692 Operating Instructions Manual

Type 8692, 8693
Installation
Control.function Pneumatic.connection.Type.8692,.8693.with.actuator
Pilot.air.outlet.
Types.8692.
and.8693
2
Process valve
closed in rest
A
position
2
(by spring force)
Process valve
2
open in rest
B
position
2
(by spring force)
Process valve
2
closed in rest
position
2
I
Process valve
2
open in rest
position
2
Table 10: Pneumatic connection to actuator
12.5 Rotating the actuator module
Type 8692/8693 with attached actuator is designated as the actuator module.
Following installation of the process valve, if display of Type 8692/8693 is only partially visible or the connection
cables or hoses are difficult to fit, the actuator module can be rotated into a suitable position.
With diaphragm valves it is not possible to turn the actuator module.
Process.valves.Types.2300.and.2301:.Only the position of the entire actuator module relative to the
valve body can be rotated. Type 8692/8693 cannot be rotated contrary to the actuator.
The process valve must be in the open position to turn the actuator module!
DANGER!
Risk.of.injury.from.high.pressure.in.the.system/device.
▶ Before loosening the lines and valves, turn off the pressure and vent the lines.
Procedure:
→
Clamp valve body in a holding device (only required if the process valve has not yet been installed).
→
Control function A: Open process valve.
Pilot.air.port.actuator
lower pilot air port of the actuator
1
should be connected to the upper pilot air port of the actuator
2
upper pilot air port of the actuator
1
should be connected to the lower pilot air port of the actuator
2
lower pilot air port of the actuator
1
upper pilot air port of the actuator
2
upper pilot air port of the actuator
1
lower pilot air port of the actuator
2
english
43