Burkert 8692 Operating Instructions Manual page 164

Operating structure:
CYCLE.COUNTER
Figure 103: Operating structure CYCLE.COUNTER
Specifying.interval.for.the.output.of.messages
Key Action
/ Select CYCLE.COUNTER
ENTER
Press
/ Select LIMIT
INPUT
Press
/
<
OK Press
EXIT Press
Table 86: CYCLE.COUNTER; specifying interval.
TEMP.CHECK –.Temperature.monitor
The temperature monitor checks whether the current temperature is within the specified temper-
ature range. The temperature range is specified by inputting a minimum and maximum temperature.
If the temperature deviates from the specified range, a message is output.
• To do this, a history entry is made in the HISTORY submenu. For description see "25.2.21.7. History entries in
the HISTORY submenu".
• The status signal, which is assigned to the message, is indicated at short intervals on the display.
See also D.MSG and CONFIG.MSG in chapter "25.2.21.5", page 154.
In addition to the monitor there is a temperature slave pointer. This indicates the lowest and highest of the measured
temperature values. The slave pointer can be reset by pressing the
164
LIMIT
ENTER
NEXT M.
HISTORY
EXIT
Description
(To do this, the CYCLE.COUNTER function must be incorporated
into the DIAGNOSE main menu. See chapter "25.2.21.4. Activation
of diagnosis functions".)
The menu is displayed.
The preset value is displayed.
Setting interval for outputting the message (limited number of
Increase value
changes in direction).
Changing the decimal
place
Return to the CYCLE.COUNTER menu.
Return to the DIAGNOSE main menu.
english
INPUT
Input change
in direction
Display the remaining changes in direction until the next
message
ENTER
History entry
is displayed
key.
CLEAR
Type 8692, 8693
Auxiliary functions
OK
ESC
Delete.history.entry
CLEAR
EXIT