Start-Up.sequence; Start-Up.sequence - Burkert 8692 Operating Instructions Manual

20 START-UP SEQUENCE
Before start-up, carry out pneumatic, fluid and electrical installation of Type 8692/8693 and of the valve.
For a description see chapters "12" und "13".
When the operating voltage is applied, Type 8692/8693 is operating and is in the AUTOMATIC operating state.
The display shows the process level with the values for POS and CMD.
The following basic settings must be made for starting up the device:
Device. Sequence Type.of.basic.setting
type
1
8692 and
8693
2
3
4
5
only 8693
(Process 6
controller)
7
8
Table 29: Start-up sequence
The basic settings are made on the setting level.
To switch from the process to the setting level, press the
Then the main menu (MAIN) of the setting level is indicated on the display.
78
Basic setting of the device:
Enter the operating mode of
the valve actuator.
Generally not required for
the initial start-up!
The operating mode of the
actuator has been preset in
the factory.
Set input signal
(standard signal).
Adjust device to the local
conditions.
Activate process controller.
Basic setting of the process
controller:
– Setting the hardware
– Parameter setting of the
software.
Automatic linearization of the
process characteristics.
Automatic parameter setting
for the process controller.
English
Type 8692, 8693
Start-Up
Setting.via
ACTUATOR
INPUT
X.TUNE
ADD.FUNCTION
P.CONTROL
→ SETUP
→ PID.PARAMETER
P.Q'LIN
P.TUNE
key for approx. 3 seconds.
MENU
Description. Requirement
in.chapter
"22.1"
essential
"22.2"
"22.3"
"23"
"24"
essential
"24.2"
"24.3"
"24.4"
to be
implemented
optionally
"24.5"