CONFIGURING.THE.AUXILIARY.FUNCTIONS. . .............................................................................................................. 108

25.1. Activating.and.deactivating.auxiliary.functions. . ............................................................................................... 108

25.1.1

Including auxiliary functions in the main menu .......................................................................... 108

25.1.2

Removing auxiliary functions from the main menu ................................................................... 109

25.1.3

Principle of including auxiliary functions in the main menu .................................................... 109

25.2. Overview.and.description.of.the.auxiliary.functions. . .................................................................................... 110

25.2.1

CHARACT - Select the transfer characteristic between input signal

(position set-point value) and stroke .......................................................................................... 111

25.2.2

CUTOFF - Sealing function ................................................................................................... 115

25.2.3

DIR.CMD - Sense of effective direction of the positioner set-point value ................ 117

25.2.4

DIR.ACT - Sense of effective direction of the actuating drive ....................................... 118

25.2.5

SPLTRNG - Signal split range .............................................................................................. 119

25.2.6

X.LIMIT - Limits the mechanical stroke range .................................................................... 120

25.2.7

X.TIME - Limiting the control speed ..................................................................................... 121

25.2.8

X.CONTROL - Parameterization of the positioner ......................................................... 122

25.2.9

P.CONTROL - Setting up and parameterization of the process controller ............... 123

25.2.10

SECURITY - Code protection for the settings ................................................................ 124

25.2.11

SAFEPOS - Input the safety position ................................................................................. 126

25.2.12

SIG.ERROR - Configuration of signal level fault detection .......................................... 127

25.2.13

BINARY.IN - Activation of the binary input ....................................................................... 128

25.2.14

OUTPUT - Configuring the outputs (option) ..................................................................... 130

25.2.15

CAL.USER - Calibration of actual value and set-point value ....................................... 136

25.2.16

SET.FACTORY - Resetting to the factory settings ....................................................... 141

25.2.17

SER. I\O - Settings of the serial interface .......................................................................... 142

25.2.18

EXTRAS - Setting the display ............................................................................................... 143

25.2.19

SERVICE ..................................................................................................................................... 145

25.2.20

SIMULATION - Menu for simulation of set-point value, process and

process valve .................................................................................................................................... 146

25.2.21

DIAGNOSE - Menu for monitoring valves (option) .......................................................... 151

25.3. Manual.configuration.of.X.TUNE.. . ...................................................................................................................... 171

25.3.1

Description of the menu for the manual configuration of X.TUNE ....................................... 172