Cooling system
- Screw the rotor. (anticlockwise thread).
Locking torques (N*m)
Water pump rotor
4 - 5 Nm (2.95 - 3.69 lb ft)
- Fit the pump cover with a new gasket, previously
lubricated with petroleum jelly grease.
- Screw the six cover screws and tighten to the
prescribed torque.
NOTE
DO NOT LUBRICATE THE O-RING WITH PETROLEUM
GREASE TO AVOID DEFORMATION.
Locking torques (N*m)
Water pump rotor cover
Removing the radiator
•
Remove the right side fairing.
•
Undo and remove the two protection
fixing screws.
•
Remove the protection.
•
Remove the expansion tank cap.
•
Place an appropriate container near
the water pump.
COOL SYS - 358
3 - 4 Nm (2.2 - 2.95 lb ft)
MSS Mana GT ABS