APRILIA MSS Mana GT ABS Service Station Manual page 121

MSS Mana GT ABS
•
Track resistance (pin 1-5 or 2-3): 1.5
kΩ.
•
Signal resistance (pin 4-5 or 3-6): Min
1.0 kΩ (released sensor) - Max. 2.5 kΩ
(rotated sensor)
Pin-out:
1. Track 1 ground (Green/Grey - Digitek Pin
A5)
2. Track 2 supply + 5 V (Yellow/Purple - Digitek
Pin A4)
3. Track 2 ground (Pink/Purple - Digitek Pin
C7)
4. Track 1 signal (Purple/Red - Digitek Pin A2)
5. Track 1 supply + 5 V (Grey/Purple - Digitek
Pin C6)
6. Track 2 signal (Green/Pink - Digitek Pin C2)
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
THE CONNECTION DIAGRAMS ARE IN THE ELECTRICAL SYSTEM SECTIONS; PAY ATTENTION
TO THESE DIAGRAMS AS THEY SHOW THE CONNECTOR/COMPONENT AS VIEWED FROM
THE CABLE HARNESS SIDE, THAT IS LOOKING AT THE CABLES WHEN GOING OUT OF THE
"MAIN" CABLE HARNESS AND INTO THE CONNECTOR/COMPONENT.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
AXONE: AUTOMATIC TRANSMISSION system
PARAMETERS
Driving pulley position potentiometer: track 1
Example value:2.02 mm
Current gap, compared to the lower mechanical stop position, based on the potentiometer track 1: to
make sure that the read value is correct, check the status of the driving pulley position Potentiometer:
track 1.
Driving pulley position potentiometer: track 1
Example value:3.5 V
Current voltage for potentiometer, track 1.
Driving pulley position potentiometer:track 2
Electrical system
ELE SYS - 121