Removing The Clutch - APRILIA MSS Mana GT ABS Service Station Manual

MSS Mana GT ABS
Removing the driving pulley
Inspecting the clutch drum
- Make sure that the clutch bell is not worn or dam-
aged.
- Measure the clutch bell inside diameter.
NOTE
CHECK THE ECCENTRICITY FOUND; IT SHOULD BE 0.2
MM MAX.
Characteristic
Max. value:
175.5 mm
Standard value:
175+0+0.2 mm

Removing the clutch

Remove the clutch with the driven pulley using the specific tool.
CAUTION
WHILE PERFORMING THESE OPERATIONS, AVOID CONTACT WITH OIL OR GREASE WHICH
COULD MAKE THE CONTACT SURFACES BETWEEN THE BELT AND THE HALF-PULLEYS
SLIPPERY.
Specific tooling
020659Y Tool to remove clutch and repl. belt
- Place the clutch assembly on the tool by inserting
the pins in the ventilation holes.
- Fit the centring bushing until it stops.
- Unscrew the ring nut with the adaptor.
Engine
ENG - 241