Gearshift Pedal - APRILIA MSS Mana GT ABS Service Station Manual

MSS Mana GT ABS
expected values, check the continuity of the yellow/pink cable and the ground connection
and then restore the cable harness.

Gearshift pedal

PEDAL GEARSHIFT CONTROL
Function
To tell the transmission ECU that the driver wishes
to change the variator transmission ratio (gear shift
in manual gear mode).
Operation / operating principle
Either control (+) or (-) is made up of a deviator
with both outputs electrically connected to the
transmission ECU.
Level in wiring diagram: transmission manage-
ment
Position:
•
pedal gearshift control on vehicle: ped-
al gearshift lever
•
connector: under the fuel tank (inside
the rubber protection housing)
Electrical characteristics
Gear upshift:
•
0 Ohm, between PIN C5 and PIN A7,
•
infinite resistance between PIN C5 and
PIN A3
Gear downshift:
•
0 Ohm between PIN C5 and PIN A6
•
infinite resistance between PIN C5 and
PIN C4
Pin-out:
Gear upshift:
•
1 - supply + 12 V (blue - black/purple)
•
2 - ground (brown - blue/black)
•
5 - supply + 12 V (red - blue/purple)
Gear downshift:
•
3 - ground (black - blue/black)
Electrical system
ELE SYS - 129