Suspensions
•
Fit the centring plate.
•
Fit the pumping member together with
the centring plate in the sleeve.
•
Insert the special washer in the screw.
•
Tighten the screw to the prescribed tor-
que.
UPON REFITTING, REPLACE THE SAFETY WASHER WITH
A NEW ONE
Locking torques (N*m)
Screw fixing the stem in wheel holder - M10x1.5
(2)
20 Nm (14.75 lbf ft)
Filling oil
NOTE
THE FOLLOWING OPERATIONS REFER TO THE MARZOCCHI FORKS.
RIGHT STEM
•
Place the stanchion on a work table in upright position.
•
Fill the sleeve with the adequate quality and type of oil indicated on the recommended prod-
ucts table.
WARNING
MOVE THE PUMPING ELEMENT SEVERAL TIMES UNTIL
AIR BUBBLES ARE SEEN ON THE OIL SURFACE.
Characteristic
Fork oil quantity (right stem) (Marzocchi)
490 cc (29.90 cu in)
Oil level (from sleeve rim, without the spring
with preload pipe and with stem at end of
stroke)
50 mm (1.97 in)
•
Insert the preload pipe.
SUSP - 298
MSS Mana GT ABS