APRILIA MSS Mana GT ABS Service Station Manual page 221

MSS Mana GT ABS
Refitting the crankcase halves
- Tighten the seven screws «B» with the copper
washers as far as they will go.
- Tighten the twelve screws «C» with the washers
as far as they will go.
- Tighten to the prescribed torque.
Locking torques (N*m)
Crankcase-engine coupling screws (M8)
- Fit the centring bushings, the washers and screw
the fixing nuts to the support.
- Turn the support so as to operate on the trans-
mission side.
- Screw the six screws «A» with the washers and
tighten to the prescribed torque.
Locking torques (N*m)
Crankcase-engine coupling screws (M6)
- Fit a new oil seal in the transmission side crank-
case half on the driving pulley axle.
- Fit the oil seal manually being careful that the in-
ternal lips are correctly placed on the crankshaft.
- With a pipe of the indicated size, inside Ø XX,X
mm - outside Ø XX,X mm, set the oil seal at the
indicated distance, check with the gauge, accord-
ing to the indications described in the figure.
Lubrication
25 - 28
11 - 13
Engine
ENG - 221