APRILIA MSS Mana GT ABS Service Station Manual page 53

MSS Mana GT ABS
•
11 - HAS THE INSTRUMENT PANEL BEEN REPLACED?
•
12 - STORE ALL THE KEYS THE FIRST TIME THE INSTRUMENT PANEL IS SWITCHED
ON - END
•
13 - DELETE THE ERROR WITH THE "ERROR CLEARING" FUNCTION IN THE "DIAG-
NOSIS" FUNCTION OF THE INSTRUMENT PANEL - END
Belt
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
•
1 - WORD "BELT" SHOWN ON THE DISPLAY
•
2 - IS THE "EFI" WARNING LIGHT ON AND THE GEARSHIFT IN "AUTOMATIC - RAIN"
MODE?
•
3 - NOW THE CURRENT BELT CAN BE USED UNTIL THE "EFI" WARNING LIGHT
COMES ON AND THERE IS A FORCED SETTING OF THE GEARSHIFT IN "AUTOMATIC
-RAIN" MODE
•
7 - HOWEVER, DO YOU WANT TO REPLACE THE BELT? YES, go to 5; NO, END
•
4 - CONNECT TO AXONE BY SELECTING "AUTOMATIC GEARSHIFT", THE "BELT
WEAR" ERROR, CODE 9011 CURR. (CURRENT) IS PRESENT.
•
5 - REPLACE THE BELT AND BEFORE STARTING THE ENGINE, REPLACE THE BELT
WITH AXONE (SEE ELECTRICAL SYSTEM/CHECKS AND CONTROLS/TRANSMISSION
ECU/ADJUSTABLE PARAMETERS).
•
6 - DELETE THE ERROR WITH THE "ERROR CLEARING" FUNCTION - END
GEAR
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
CAUTION
BEFORE ANY TROUBLESHOOTING, MAKE SURE THAT:
1) BATTERY VOLTAGE IS ABOVE 12V;
2) THE MAIN 30A FUSE IS NOT DAMAGED AND IS ADEQUATELY FITTED;
3) SECONDARY FUSES ARE NOT DAMAGED AND ARE ADEQUATELY FITTED.
1 - "EFI" WARNING LIGHT IS ON AND THE WORD "GEAR" IS SHOWN ON THE DISPLAY
2 - CONNECT TO AXONE BY SELECTING "AUTOMATIC GEARSHIFT" AND CHECK WHICH ER-
ROR IS PRESENT: FOR FURTHER INFORMATION ABOUT THE ERROR AND ITS POSSIBLE
CAUSES, PUSH BUTTON "?". THE AMBIENT PARAMETERS RELATED TO THE ERROR CAN ALSO
YES, go to 12; NO, go to 13.
YES, go to 4; NO, go to 3.
Troubleshooting
TROUBL - 53