APRILIA MSS Mana GT ABS Service Station Manual page 341

MSS Mana GT ABS
•
So that the brake fluid remains in the
ABS control unit, first remove the pro-
tective caps of the braking circuit un-
ions and connect the respective pipes.
Once all the braking circuits have been con-
nected, remove the protective caps from the
braking pump unions and connect the braking
pump pipes to the ABS control unit.
•
Unlock the lever and the brake pedal.
•
Remove the cap of the reservoir and fill
it with the new DOT 4 brake fluid up to
the reference "MAX".
CAUTION
PERFORM THE REGULAR BRAKING SYSTEM BLEED, AS
DESCRIBED AT THE BEGINNING OF THE CHAPTER.
•
Always fill the reservoir up to the reference "MAX" and refit the cap.
•
Check the stroke and the sensitivity of both the lever and the brake pedal.
•
If after bleeding, the pedal or the lever stroke is too long, check that there are no leaks in
the braking system and if everything is ok, continue bleeding operations using Axone as
described.
•
Detach the bleed hoses and close the bleed screws again to the correct tightening torque.
BRAKE BLEEDING AFTER CALLIPER RE-
PLACEMENT
VEHICLE PREPARATION - The operations are
described for the front system, but they are al-
so valid for both braking systems.
•
Connect the bleed bottles to the bleed
screw of the front calliper and open it.
•
Fully press down the brake lever and
fasten it into position with a locking de-
vice so as to avoid fluid flowing out from
the open system.
•
Close the bleed screws of the front cal-
liper and remove the bleed bottle.
•
Replace the damaged calliper with a
new one.
•
Unlock the brake lever.
Braking system
BRAK SYS - 341