Checking The Front Wheel; Front Wheel Bearings - APRILIA MSS Mana GT ABS Service Station Manual

MSS Mana GT ABS
•
Tap the wheel axle slightly with a rub-
ber mallet so that the hole on the op-
posite side is exposed.
•
Remove the wheel axle by inserting a
screwdriver in the holes on the pin.
•
During extraction, support the wheel and then remove it.
•
Collect the spacer from the front wheel
left side.

Checking the front wheel

FRONT WHEEL BEARINGS

Carry out the check with the bearings fitted on the wheel.
CHECK THAT ALL PARTS ARE IN GOOD CONDITION, ESPECIALLY THOSE LISTED AS FOL-
LOWS.
ROTATION CHECK
•
Manually rotate the inside ring of each bearing. Rotation must be constant, smooth and
noiseless.
If one or both bearings do not fall within the control parameters:
•
Replace both wheel bearings.
RADIAL AND AXIAL CLEARANCE CHECK
•
Check the radial and axial clearance.
Axial clearance: a minimum axial clearance is allowed.
Radial clearance: none.
If one or both bearings do not fall within the control parameters:
•
Replace both wheel bearings.
Suspensions
SUSP - 273