MSS Mana GT ABS
Engine temperature sensor
ENGINE TEMPERATURE SENSOR
Function
it tells the engine temperature to the control unit so
as to optimise its operation.
Operation / Operating principle
NTC type sensor (resistance sensor, inversely
variable with temperature).
Level in wiring diagram:Temperature sensors
Location:
•
on the vehicle: rear cylinder, internal
area
•
connector: on the sensor
Electrical characteristics:
•
Resistance at 25°: 2.05 kOhm +/- 100
Ohm
•
Resistance at 60°: 575 Ohm +/- 15
Ohm
•
Resistance at 90°: 230 Ohm +/- 5 Ohm
Pin-out:
•
Orange: 0-5 V signal: PIN B1
•
Grey: Ground connection: PIN B2
THE CONNECTION DIAGRAMS ARE IN THE ELECTRICAL SYSTEM SECTIONS; PAY ATTENTION
TO THESE DIAGRAMS AS THEY SHOW THE CONNECTOR/COMPONENT AS VIEWED FROM
THE CABLE HARNESS SIDE, THAT IS LOOKING AT THE CABLES WHEN GOING OUT OF THE
"MAIN" CABLE HARNESS AND INTO THE CONNECTOR/COMPONENT.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
AXONE: FUEL INJECTION SYSTEM
PARAMETERS
Engine temperature
Example value: 75° C
In case of recovery, this value is set by the control unit.
ELECTRICAL ERRORS
engine temperature sensor P0115 - open circuit, shorted to positive / shorted to negative.
Error cause
Electrical system
ELE SYS - 95