APRILIA MSS Mana GT ABS Service Station Manual page 247

MSS Mana GT ABS
Refitting the clutch
- Prepare the specific tool for the removal phase.
- Preassemble the driven pulley unit.
- Fit the driven pulley unit, the spring with sheath
and clutch into the tool.
CAUTION
WHILE PERFORMING THESE OPERATIONS, AVOID CON-
TACT WITH OIL OR GREASE WHICH COULD MAKE THE
CONTACT SURFACES BETWEEN THE BELT AND THE
HALF-PULLEYS SLIPPERY.
Specific tooling
020659Y Tool to remove clutch and repl. belt
- Compress the spring and fit the clutch on the
driven pulley bushing.
NOTE
BE CAREFUL NOT TO DAMAGE THE SHEATH OR THE
BUSHING THREADED END.
- Screw the locking ring nut and tighten to the pre-
scribed torque.
Locking torques (N*m)
Clutch ring nut
65 - 75
- With a specific tool, separate the two half-pulleys
and fit the belt according to its direction of rotation.
CAUTION
PLACE THE TWO HALF-RINGS CORRECTLY SO THAT
THEY PERFECTLY ADHERE TO THE HALF-PULLEY.
Engine
ENG - 247