Warning Lights - APRILIA MSS Mana GT ABS Service Station Manual

MSS Mana GT ABS
•
59 - RESTORE THE CABLE HARNESS - END
•
60 - RESTORE THE CABLE HARNESS - END
FAILURE INDICATIONS ON INSTRUMENT PANEL DISPLAY

WARNING LIGHTS

•
Instrument panel (hardware) identical to that of the vehicle without ABS system (there is no
dedicated warning light).
•
Software version must be M2MAN0006 or higher (to check the current version connect/
disconnect battery).
•
The system can not be disconnected (there is no ON/OFF switch).
•
Each time the key is ON, the module performs a check of the system (flashing EFI warning
light and ABS word on the display) that is completed when the 5 km/h (3.11 mph) are ex-
ceeded and the EFI warning light turns off and the ABS word disappears.
•
In case of an error in the ABS system, the steady EFI warning light turns on and the ABS
word appears on the display.
CAUTION
IF THE EFI WARNING LIGHT FLASHES WITH THE ABS WORD STEADY ON THE DISPLAY, THE
ABS SYSTEM IS NOT ACTIVATED.
INSTRUMENT PANEL OFF
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
•
1 - KEY ON, THE INSTRUMENT PANEL DOES NOT TURN ON
•
2 - IS THE FUEL PUMP ACTIVATED?
•
3 - CHECK THE INSTRUMENT PANEL CONNECTOR AND CHECK IF THERE IS CON-
TINUITY IN THE GREEN CABLE FROM AUXILIARY FUSE TO PIN 1 OF THE INSTRU-
MENT PANEL CONNECTOR - END
•
4 - DETACH THE MAIN INJECTION RELAY: IS IT ON THE GREEN/BLACK CABLE?
•
5 - DETACH THE KEY SWITCH CONNECTOR: IS THERE VOLTAGE IN THE WHITE/RED
CABLE?
•
6 - CHECK THE KEY SWITCH CONNECTOR AND CHECK IF THERE IS CONTINUITY IN
THE WHITE/RED FROM THE 30A FUSE TO THE KEY SWITCH CONNECTOR - END
•
7 - CHECK CONTINUITY OF THE KEY SWITCH - END
YES, go to 3; NO, go to 4.
YES, go to 8; NO, go to 5.
YES, go to 7; NO, go to 6.
Troubleshooting
TROUBL - 51