APRILIA MSS Mana GT ABS Service Station Manual page 125

MSS Mana GT ABS
Potentiometer reset, Phase 2
Follow the procedure step by step as indicated in the different screen pages (yellow or black label OBD
module without 2006 legend).
Entering the gearshift stroke category
If the ECU is replaced, the gearshift stroke category can be entered in the new ECU (reading the
category in the old ECU). The categories range from 1 to 8.
Gearshift stroke default value setting:
Setting to be used if a component of the variator that affects the gearshift stroke has been replaced.
See also
Refitting the driving pulley
Driven pulley speed sensor
Function
To indicate the driven pulley speed by reading the
speed of rotation of the fixed half-pulley that has
four studs.
Operation / Operating principle
Inductive sensor: sinusoidal alternating current is
generated (approximately 0.7 V at idle speed) for
the transmission ECU reading.
Level in wiring diagram:transmission manage-
ment
Location:
•
on the vehicle: on the crankcase cover,
driven pulley upper part.
•
under the fuel tank (within the protec-
tive rubber cap).
Electrical specifications: Coil resistance at Am-
bient temperature: 0.7 - 1.1 kOhm.
Pin-out:
1. Signal (cable colour not defined)
2. Ground (cable colour not defined)
3. Shielding
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
Electrical system
ELE SYS - 125