TUAREG 660
•
Ensure that the pin (A) cannot rotate,
and then tighten the nut until the seal-
ing ring is fully seated.
•
Insert the impeller (5) and tighten it to
the prescribed torque.
Removing the radiator
To remove the radiator it is necessary to remove
the fuel tank, sump guard and the side fairings.
Then proceed as described:
•
Remove the expansion tank cap (1).
•
Operating on the left side of the motor-
cycle, remove the screw (2) to com-
pletely drain the cooling system, taking
care to collect the metal washer.
DURING REPLACEMENT, USE A NEW SEAL-
ING WASHER.
Cooling system
COOL SYS - 269