Bank Angle Sensor - APRILIA MSS Mana GT ABS Service Station Manual

Electrical system
•
Indication on Axone always down: check the connector: if not OK, restore; if it is OK, dis-
connect the two terminals from the sensor and check continuity to ground of PIN 1: if there
is no continuity, restore the cable harness; if there is, replace the sensor
•
Indication on Axone always up: disconnect the terminals from the sensor and check if there
is continuity between the two PINS, with stand down: if there is continuity, replace the sensor;
if the circuit is open, it means that on the brown/green cable from sensor PIN 2 to PIN 38 of
connector B (BLUE) there is a short circuit to ground: restore the cable harness

Bank angle sensor

FALL SENSOR
Function
it tells the vehicle position to the control unit.
Operation / Operating principle
When the sensor is inverted, the circuit is closed
to ground: When the Marelli control unit detects
this ground connection, it does not enable start-up
or shuts off the engine.
Level in wiring diagram:Start-up enabling
switches.
Location:
•
on the vehicle: under the saddle, front
area near the control unit
•
connector: near the sensor
Electrical characteristics:
•
Sensor in vertical position: open circuit
(resistance: 62 kOhm)
•
Sensor inverted: closed circuit (con-
tinuity)
Pin-out:
1. Ground connection
2. Voltage 5V
THE CONNECTION DIAGRAMS ARE IN THE ELECTRICAL SYSTEM SECTIONS; PAY ATTENTION
TO THESE DIAGRAMS AS THEY SHOW THE CONNECTOR/COMPONENT AS VIEWED FROM
THE CABLE HARNESS SIDE, THAT IS LOOKING AT THE CABLES WHEN GOING OUT OF THE
"MAIN" CABLE HARNESS AND INTO THE CONNECTOR/COMPONENT.
CAUTION
ELE SYS - 110
MSS Mana GT ABS