APRILIA MSS Mana GT ABS Service Station Manual page 109

MSS Mana GT ABS
Side stand sensor
SIDE STAND SENSOR
Function
It tells the side stand position to the control unit.
Operation / Operating principle
If vehicle speed is equal to zero and with the stand
down, start-up is attempted, a restriction to engine
revolutions is activated. If the vehicle is moving
and the stand is extended, the ECU injection stops
the engine.
Level in wiring diagram:start-up enabling
switches
Location:
•
on the vehicle: on the side stand
•
connector: under the fuel tank (inside
the rubber protection housing)
Electrical specifications:
•
Side Stand Up: closed circuit (continu-
ity)
•
Side Stand Down: open circuit (infinite
resistance)
Pin-out:
1. Ground connection
2. Voltage 12V
THE CONNECTION DIAGRAMS ARE IN THE ELECTRICAL SYSTEM SECTIONS; PAY ATTENTION
TO THESE DIAGRAMS AS THEY SHOW THE CONNECTOR/COMPONENT AS VIEWED FROM
THE CABLE HARNESS SIDE, THAT IS LOOKING AT THE CABLES WHEN GOING OUT OF THE
"MAIN" CABLE HARNESS AND INTO THE CONNECTOR/COMPONENT.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
AXONE: FUEL INJECTION SYSTEM
STATUSES
Side stand
Example value:up/down
Troubleshooting
Electrical system
ELE SYS - 109