APRILIA MSS Mana GT ABS Service Station Manual page 67

MSS Mana GT ABS
TABLE O
16. Clamp to chassis
TABLE P
Procedure for the correct insertion of the ABS control unit connector
The initial position of the lever that couples the connector must be as shown in the figure.
TABLE P1
Place the connector on the opposite side of the
control unit and lower the driving lever until the
"click" that signals the end of the stroke is heard.
TABLE P2
When the connector is fully inserted, the distance between the connector and the ABS control unit must
be 7.5 mm (0.295 in).
If the initial positions of the connector and the driving lever are not those described in P1, the connector
will not be properly coupled and the distance measured will be greater (12 mm approx. (0.47 in).
In this case repeat the operation as described in P, P1, P2.
It is advisable to create a template to check the correct connector insertion.
Electrical system
ELE SYS - 67