Electric Lock; Run/Stop Switch - APRILIA MSS Mana GT ABS Service Station Manual

Electrical system

Electric lock

ELECTRIC LOCK
Function
To open the helmet compartment.
Level in wiring diagram:Services.
Location:
•
on the vehicle: under key block, left
side
•
connector: on electric lock
Electrical characteristics:
•
150 Ohm +/- 20 %
Pin-out:
1. Ground.
2. Supply.
THE CONNECTION DIAGRAMS ARE IN THE ELECTRICAL SYSTEM SECTIONS; PAY ATTENTION
TO THESE DIAGRAMS AS THEY SHOW THE CONNECTOR/COMPONENT AS VIEWED FROM
THE CABLE HARNESS SIDE, THAT IS LOOKING AT THE CABLES WHEN GOING OUT OF THE
"MAIN" CABLE HARNESS AND INTO THE CONNECTOR/COMPONENT.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.

RUN/STOP switch

Run / stop switch
Function
It tells the control unit if the driver wishes to enable
engine start-up or to keep the engine running.
Operation / Operating principle
If the driver wants to shut off the engine or to dis-
able engine start-up, the switch should be open,
i.e. the Marelli control unit should not detect volt-
age at PIN 27 of connector B "BLUE".
Level in wiring diagram:Start-up enabling
switches.
Location:
•
on the vehicle: right light switch
ELE SYS - 114
MSS Mana GT ABS