Suzuki Liana RH418 Supplementary Service Manual page 241

• A: Driving cycles when "O/D OFF" light flashing and storing DTC in TCM memory.
• *1: "O/D OFF" lamp does not flash although DTC is detected and stored in TCM memory.
DTC No.
Type I Type II
Control Module Programming
P0602 —
error
Transmission range sensor
P0705 34 circuit malfunction (PRNDL
input)
36
Transmission fluid temperature
P0710
sensor circuit malfunction
38
Input/Turbine speed sensor
P0715 37
circuit malfunction
Output speed sensor (VSS)
P0720 31
circuit malfunction
Engine speed input circuit
P0725 35
malfunction
25
Torque converter clutch circuit
P0743
electrical
26
41
Pressure control solenoid "A"
P0748
42 electrical
21
Shift solenoid-A (No.1)
P0753
electrical
22
23
Shift solenoid-B (No.2)
P0758
electrical
24
32
Throttle position signal input
P1700
malfunction
33
Internal control module
P1702 52
memory check sum error
Engine coolant temperature
P1705 51
signal circuit malfunction
Engine torque signal circuit
P1730 64
malfunction
Torque control signal circuit
P1895 27
malfunction
Detecting item
Internal Control Module programming error.
Multiple signals are inputted simultaneously.
No sensor signal is inputted.
Sensor output voltage is too high
(Circuit open or shorted to power circuit)
Sensor output voltage is too low
(Circuit shorted to ground)
No sensor signal is detected although output
shaft speed sensor signal is detected.
No sensor signal is inputted although input shaft
speed sensor signal is inputted.
No engine speed signal is inputted although
engine is running and engine temperature sensor
signal is in normal condition.
Voltage of TCC solenoid terminal is high although
TCM is commanding TCC solenoid to turn OFF.
Voltage of TCC solenoid terminal is low although
TCM is commanding TCC solenoid to turn ON.
No electric flow is detected on solenoid circuit.
Too much electric flow is detected on pressure
control solenoid circuit.
Voltage of shift solenoid terminal is high although
TCM is commanding shift solenoid to turn OFF.
Voltage of shift solenoid terminal is low although
TCM is commanding shift solenoid to turn ON.
Voltage of shift solenoid terminal is high although
TCM is commanding shift solenoid to turn OFF.
Voltage of shift solenoid terminal is low although
TCM is commanding shift solenoid to turn ON.
Too short low signal of pulse signal from ECM to
TCM continues out of specification.
Too long low signal of pulse signal from ECM to
TCM continues out of specification.
Calculation of current data stored in TCM is not
correct comparing with pre-stored checking data
in TCM.
• Too long high signal of pulse signal from ECM
or
• Too long low signal of pulse signal from ECM
• Too long high signal of pulse signal from ECM
or
• Too long low signal of pulse signal from ECM
Voltage of torque reduction signal circuit terminal
is low although TCM does not require ECM to
reduce engine torque.
Automatic Transmission/Transaxle:
Detecting condition
(DTC will set when detecting:)
to TCM continues out of specification.
to TCM continues out of specification.
to TCM continues out of specification.
to TCM continues out of specification.
5A-15
A
—
1 driving
cycle *1
2 driving
cycles *1
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle
1 driving
cycle