Suzuki Liana RH418 Supplementary Service Manual page 329

4) Remove front ring gear thrust washer (1).
Front ring gear thrust washer dimension
Outside diameter: 85.5 mm (3.67 in.)
Inside diameter: 70.0 mm (2.76 in.)
Thickness: 2.0 mm (0.08 in.)
5) Remove front ring gear thrust roller bearing race (1).
Front ring gear thrust roller bearing race
dimension
Outside diameter: 80.4 mm (3.17 in.)
Inside diameter: 68.0 mm (2.68 in.)
Thickness: 0.8 mm (0.03 in.)
6) Remove front ring gear thrust roller bearing (1).
Front ring gear thrust roller bearing dimension
Outside diameter: 83.5 mm (3.29 in.)
Inside diameter: 64.5 mm (2.54 in.)
Thickness: 2.7 mm (0.11 in.)
7) Remove thrust washer (2).
Automatic Transmission/Transaxle:
8) Remove front ring gear flange (1) by removing snap
ring (2).
9) Remove O-ring (1).
NOTE
Never reuse O-ring (1) after removal.
I2RH01510170-01
Rear planetary ring gear assembly
1) Remove sun gear thrust roller bearing race (1).
Sun gear thrust roller bearing race dimension
Outside diameter: 29.6 mm (1.17 in.)
Inside diameter: 19.2 mm (0.76 in.)
I2RH01510171-01
Thickness: 0.8 mm (0.03 in.)
2) Remove carrier rear thrust roller bearing (2).
Carrier rear thrust roller bearing dimension
Outside diameter: 70.9 mm (2.79 in.)
Inside diameter: 57.0 mm (2.24 in.)
Thickness: 2.6 mm (0.10 in.)
3) Remove rear ring gear flange (3) by removing snap
ring (4).
I2RH01510172-01
5A-103
I2RH01510173-01
I2RH01510174-01
I2RH01510175-01