6) Rotate new spacer approximately 180 degrees.
7) Stake small hole of new spacer.
8) Press counter drive gear (1), using special tools.
Special tool
(A): 09924-74510
(B): 09926-68310
9) Install new snap ring (1) to angular ball bearing.
Automatic Transmission/Transaxle:
10) Apply A/T fluid to new O-rings.
11) Place 1st and reverse brake piston (1) with O-rings
installed.
NOTE
Be careful not to damage O-rings during
piston installation.
I2RH01510234-01
12) Mount 1st and reverse brake piston return spring (2).
13) Install retainer ring (1) by compressing brake piston
return spring with flat end rod or the like.
I2RH01510235-01
14) Install separator plates "S", friction plates "F" and
retaining plates "R" in the following order.
R → F → S → F → S → F → S → F → S → F → R
15) Install snap ring (1).
NOTE
Make sure that opening end of snap ring
should be aligned with protrusion of
transaxle case.
I2RH01510236-01
5A-123
I2RH01510237-01
I2RH01510238-01
I2RH01510121-01