Overdrive Clutch And Coast Clutch Inspection 5A-100 - Suzuki Liana RH418 Supplementary Service Manual

5A-100 Automatic Transmission/Transaxle:
12) Install forward clutch assembly and overdrive and
coast clutch assembly to transaxle rear cover.
13) Measure overdrive clutch piston stroke again, using
special tools.
Special tool
(A): 09900–20607
(B): 09900-20701
Overdrive clutch piston stroke
Standard: 1.04 – 1.36 mm (0.041 – 0.054 in.)
1. Transaxle rear cover
2. Overdrive / coast clutch assembly
14) Measure coast clutch piston stroke again, using
special tools.
Special tool
(A): 09900–20607
(B): 09900-20701
Coast clutch piston stroke
Standard: 2.68 – 3.02 mm (0.106 – 0.119 in.)
Overdrive Clutch and Coast Clutch Inspection
1) Check that sliding surfaces of friction, separator and
retaining plates are not worn or burnt. If necessary,
replace.
NOTE
• If friction plate lining is exfoliated,
discolored or worn hardly, replace all
friction plates.
• Before assembling new friction plates,
soak them in A/T fluid for at least two
hours.
2) Measure height of overdrive clutch return spring.
Overdrive clutch return spring height
I2RH01510160-01
Standard: 18.9 mm (0.74 in.)
NOTE
Do not apply excessive force when
measuring spring height. Perform
measurement at several points.
3) Check that ball (1) makes creaking noise when
shaking piston clockwise and counterclockwise. (i.e.,
check that ball is free.)
I2RH01510161-01
S3RH0B5106037
I2RH01510147-01
I2RH01510162-01
I2RH01510163-01