Suzuki Liana RH418 Supplementary Service Manual page 330

5A-104 Automatic Transmission/Transaxle:
4) Remove on-way clutch No.0 retainer (1) with rear
ring gear thrust roller bearing (2) by removing snap
ring (3).
Rear ring gear thrust roller bearing dimension
Outside diameter: 32.5 mm (1.28 in.)
Inside diameter: 18.8 mm (0.74 in.)
Thickness: 2.7 mm (0.11 in.)
Reassembly
Planetary gear assembly
1) Apply A/T fluid to new O-ring (1).
2) Install O-ring (1).
3) Install front ring gear flange (1) with snap ring (2).
4) Coat thrust washer (2) with A/T fluid.
5) Install thrust washer (2).
6) Install front ring gear thrust roller bearing (1).
7) Apply A/T fluid to front ring gear thrust roller bearing
race (1) and install it.
I2RH01510176-01
8) Apply A/T fluid to front ring gear thrust washer (1)
and install it.
I2RH01510174-01
9) Set one-way clutch No.1 and one-way clutch No.1
inner race.
NOTE
• Make sure that "A" section (shorter than
rear) of inner race faces toward front side.
• Make sure that thinner section "B" of one-
I2RH01510173-01 way clutch faces toward rear side.
I2RH01510172-01
I2RH01510171-01
I2RH01510170-01
I2RH01510177-01