Distance Between Input Shaft End And Mating Surface Of Transaxle Case - Suzuki Liana RH418 Supplementary Service Manual

5A-128 Automatic Transmission/Transaxle:
56) Check for correct installation of input shaft as
follows.
Measure the distance "a" by using vernier (1) and
straightedge (2). If out of specification, remove input
shaft (3) with reverse clutch assembly and reinstall
them properly.
Distance between input shaft end and mating
surface of transaxle case
"a": 85.65 – 86.39 mm (3.372 – 3.401 in.)
57) Tighten manual detent spring (1) with bolts (2).
Tightening torque
Manual detent spring bolt (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
NOTE
It is recommended to set to neutral position
between spring detent and lever manual
valve and then tighten bolts.
58) Install oil strainer (1).
NOTE
When overhauling automatic transaxle,
replace oil strainer.
59) Tighten oil reservoir plate (2) with bolts.
Tightening torque
Oil reservoir plate bolt (a): 5.5 N·m (0.55 kgf-m,
4.0 lb-ft)
60) Install three new gaskets (1).
61) Install differential gear assembly (2).
62) Tighten oil pump body (3) with six bolts.
Tightening torque
Oil pump body bolt (a): 30 N·m (3.0 kgf-m, 22.0
lb-ft)
63) Wipe off and clean mating surface between case
and housing.
I2RH01510254-01
64) Apply sealant to transaxle case by using a nozzle (4)
as shown in figure by such amount that its section is
1.5 mm (0.059 in) in diameter.
"A": Sealant 99000–31230
I2RH01510255-01
I2RH01510256-01
I2RH01510257-01