Drive Shaft Damper Installing Position - Suzuki Liana RH418 Supplementary Service Manual

3A-7 Drive Shaft / Axle:
4) Fasten wheel side boot small band using special
tool.
NOTE
• Boot small band must not come out of its
installed position.
• Be sure to fasten boot small band securely
until complete contact "a" is obtained.
Special tool
(A): 09943–57010
5) Apply grease to wheel side joint. Use specified
grease in replacement part set.
6) Install wheel side boot so that its convex section (2)
fits in dent section (1) in wheel side joint housing.
2
1
7) Place wheel side boot big band onto boot putting
band outer end (1) against forward rotation (2) as
shown in figure.
"a"
(A)
I4RH01311005-01
I4RH01311006-01
1
2
I3RH0B311002-01
8) Confirm that wheel side boot is not stretched and
contracted, and then fasten boot big band (1)
securely using special tool.
Special tool
(A): 09943–57010
1
9) Install damper (1) on drive shaft according to
dimension specified as follows.
Drive shaft damper installing position (distance
"a" between reference position and damper)
Right side drive shaft: 154.3 – 160.3 mm (6.08 –
6.31 in.)
Left side drive shaft: 187.0 – 193.0 mm (7.37 –
7.58 in.)
10) Set new differential side small band and new
differential side boot (1) on shaft temporarily, and
then apply grease to tripod joint (2). Use specified
grease in tube included in spare parts.
11) Install tripod joint spider (3) on shaft by using special
tool with hammer, directing its chamfered spline
toward wheel side, and then fasten it with new snap
ring (4).
Special tool
(A): 09900-06107
(B): 09941–74910
(A)
I3RH0B311003-01
I2RH01310033-01
I3RH0A311006-01