Suzuki Liana RH418 Supplementary Service Manual page 353

43) Install five gaskets (1).
NOTE
There is no installation direction for new
gaskets.
44) Apply sealant to thread parts of 2 bolts (3).
"A": Sealant 99000–31230
45) Tighten transaxle rear cover (1) and engine
mounting LH bracket (2) with ten bolts (3, 4).
Tightening torque
Transaxle rear cover bolt (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
46) Turn over transaxle.
47) Remove transaxle housing.
48) Remove oil pump body, reverse clutch assembly and
2nd and 4th brake band from transaxle case.
Automatic Transmission/Transaxle:
49) Apply A/T fluid to counter shaft LH thrust roller
bearing (1).
Counter shaft LH thrust roller bearing dimension
Outside diameter: 66.0 mm (2.60 in.)
Inside diameter: 50.0 mm (1.97 in.)
Thickness: 2.7 mm (0.11 in.)
I2RH01510249-01
50) Install counter driven gear.
51) Install parking lock rod (2) with parking lock paw (1),
parking lock pawl bracket (3) and torsion spring (5).
52) With spacer and torsion spring (6) placed, install bolt
and tighten parking lock pawl bracket (3).
Tightening torque
Parking lock pawl bracket bolt (a): 10 N·m (1.0
kgf-m, 7.5 lb-ft)
53) Insert parking lock rod (2) to parking lock pawl
bracket (3) and connect parking lock rod (2) with
manual valve lever (4).
54) Install 2nd and 4th brake band (1).
55) Install reverse clutch assembly (2) while rotating
counterclockwise and clockwise.
I3RH0B510035-01
5A-127
I2RH01510251-01
I2RH01510252-01
I2RH01510253-01