Forward Clutch Disassembly And Reassembly - Suzuki Liana RH418 Supplementary Service Manual

Forward Clutch Disassembly and Reassembly

Disassembly
1) Remove snap ring (1).
2) Remove retaining plate "R", friction plates "F" and
separator plates "S" in the following order.
R → F → S → F → S → F → S
3) Remove clutch drum thrust washer.
4) Using special tool and hydraulic press (2), compress
forward clutch return spring subassembly and
remove snap ring (1).
Special tool
(A): 09926-98330
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
forward clutch return spring subassembly to
deform.
5) Remove forward clutch return spring subassembly
(3).
6) Install forward clutch piston subassembly (1) to
S3RH0B5106032 transaxle rear cover (2).
7) Remove forward clutch piston subassembly (3) with
O-rings installed through oil hole (4) compressed air
(400 – 800 kPa, 4 – 8 kg/cm
NOTE
• If piston does not pop out, it is
recommended to use needle-nose pliers
for removal.
• Never reuse removed O-rings.
I2RH01510139-01
8) Remove clutch drum oil seal rings (3) from forward
clutch drum subassembly (1).
9) Remove rear cover oil seal rings (4) from transaxle
rear cover (2).
I2RH01510140-01
Automatic Transmission/Transaxle:
2 , 57 – 113 psi).
5A-93
I2RH01510141-01
I3RH0B510033-01