Suzuki Liana RH418 Supplementary Service Manual page 311

19) Remove valve body connector mounting bolt and
remove valve body connector and its harness.
20) Remove 2 gaskets (1).
NOTE
Never reuse removed gaskets.
21) Remove snap ring (1) using special tool.
Special tool
(A): 09900-06108
22) Pull out 2nd and 4th brake cover (2) with O-ring by
using pliers or the like.
23) Inspect 2nd and 4th brake piston rod stroke.
a) Set dial gauge and magnetic stand (special
tools).
Special tool
(A): 09900–20607
(B): 09900-20701
b) Plug oil hole (1).
c) Measure piston rod stroke while applying and
releasing compressed air (400 – 800 kPa, 4 – 8
kg/cm
2nd and 4th brake piston rod stroke
Standard: 1.78 – 2.22 mm (0.070 – 0.087 in.)
NOTE
If piston rod stroke exceeds the
specification, adjust piston rod or inspect
band assembly of 2nd and 4th brake for
damage, wear or discoloration.
I2RH01510108-01
24) Pull out reverse clutch assembly (1).
25) Remove 2nd and 4th brake band assembly (2).
26) Remove anchor pin (3).
I2RH01510109-01
I2RH01510110-01
Automatic Transmission/Transaxle:
2 , 57 – 113 psi) from oil hole (2).
5A-85
I2RH01510111-01
I2RH01510112-01