Suzuki Liana RH418 Supplementary Service Manual page 160

1D-34 Engine Mechanical:
6) Tighten camshaft housing bolts in such order as
indicated in the figure a little at a time till they are
tightened to specified torque.
NOTE
Do not rotate camshaft while gauging plastic
is installed.
Tightening torque
Camshaft housing bolt (a): Tighten 11 N⋅m (1.1
kgf-m, 8.0 lb-ft) by the specified procedure
"10" "9" "2" "1",(a) "6" "5"
"20"
"17"
"19"
"18"
"21"
"12" "11" "4" "3"
7) Remove housing, and using scale (2) on gauging
plastic envelop, measure gauging plastic (1) width at
its widest point.
Camshaft journal clearance
Item Standard
Intake side 0.020 – 0.072 mm
No.1 housing (0.0008 – 0.0028 in.)
0.045 – 0.087 mm
Others
(0.0018 – 0.0034 in.)
"14" "13"
"8" "7" "16" "15"
I3RH0B140041-01
Limit
0.10 mm
(0.0039 in.)
0.12 mm
(0.0047 in.)
I2RH0B140083-01
If measured camshaft journal clearance exceeds
limit, measure journal (housing) bore and outside
diameter of camshaft journal. Replace camshaft or
cylinder head assembly whichever the difference
from specification is greater.
Camshaft journal specification
Item
Intake side
No.1 housing
Camshaft
Exhaust side
journal
No.1 housing
diameter [A]
Others
Intake side
Camshaft No.1 housing
journal Exhaust side
bearing bore No.1 housing
[B]
Others
Standard
26.940 – 26.955 mm
(1.0607 – 1.0612 in.)
26.934 – 26.955 mm
(1.0604 – 1.0612 in.)
22.934 – 22.955 mm
(0.9030 – 0.9037 in.)
—
27.000 – 27.021 mm
(1.0630 – 1.0638 in.)
23.000 – 23.021 mm
(0.9056 – 0.9063 in.)
I2RH0B140084-01