1D-10 Engine Mechanical:
Air Cleaner Element Removal and Installation
Removal
1) Disconnect air cleaner outlet No.1 hose (1) from air
cleaner case (2).
2) Open air cleaner case by unhooking its clamps.
3) Remove air cleaner element from case.
2
Installation
Reverse removal procedure for installation.
Air Cleaner Element Inspection and Cleaning
Inspection
Check air cleaner element for dirt. Replace excessive
dirty element.
Cleaning
Blow off dust by compressed air from air outlet side of
element.
Repair Instructions
Accelerator Cable Adjustment
S3RH0B1406001
With accelerator pedal depressed fully, check clearance
between throttle lever (1) and lever stopper (2) (throttle
body) which should be within the following specification.
If measured value is out of specification, adjust it to
specification with cable adjusting nut (3).
Clearance between throttle lever and lever stopper
(with pedal depressed fully)
"a": 0.5 – 2.0 mm (0.02 – 0.07 in.)
1
I2RH0B140009-01
S3RH0B1406002
I3RH0A140002-01
S3RH0B1406003
I2RH0B140017-01