Suzuki Liana RH418 Supplementary Service Manual page 351

24) Install brake cover (1) to transaxle case with snap
ring (2), using snap ring pliers.
Special tool
(A): 09900-06108
NOTE
It is best for the head section of piston rod (1)
to protrude from the inner side of transaxle
case approx. 2 – 3 mm (0.079 – 0.118 in.)
25) Apply A/T fluid to outer surface of three pins (1, 2, 3).
26) Insert three pins to transaxle case.
Pin Dimension
(1)
Outer diameter 8.0 mm
(0.31 in.)
Length 45.0 mm
(1.77 in.)
I2RH01510239-01
I2RH01510109-01
I2RH01510240-01
(2) (3)
10.0 mm 12.0 mm
(0.39 in.) (0.47 in.)
33.7 mm 45.9 mm
(1.33 in.) (1.81 in.)
Automatic Transmission/Transaxle:
27) Apply A/T fluid to transaxle lubrication tube (1).
28) Install transaxle lubrication tube (1).
29) Tighten clamp with bolt.
Tightening torque
Lubrication tube clamp bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
30) Install 2nd and 4th brake band (1).
31) Install 1st and reverse clutch assembly (2).
32) Temporarily tighten bolts of oil pump body (1).
5A-125
I2RH01510241-01
I2RH01510242-01
I2RH01510243-01
I2RH01510244-01